1Make sure the printer is on and the roll paper cover is closed.
2Press the Paper Source button until the Sheet light comes on.
3Push the paper lever back to the released position.
4Feed the sheet into the paper slot. Make sure the right edge of the paper is straight and aligned with the scale on the roll paper cover.
INCH
MM
For a large sheet of paper, feed it so that it comes out below. Then align the edges of the sheet with the rows of holes as shown.
For heavy paper, you may need to increase the suction strength by pressing the 
button. This helps hold the paper in place during loading and printing.
For lightweight paper, decrease the suction by pressing the 
button.
5Return the paper lever to the locked position.
6Press the Pause button. The sheet feeds into the printing position automatically and READY appears on the control panel.
To avoid damaging the printer, never move the paper lever during printing, or while the Operate or Pause light is flashing.
7Print your page. After it is finished, the sheet stays in the printer.
8To remove your print, press the Paper Feed 
button.
Printing on Posterboard
When you print on posterboard or other thick media (more than 19 mil thick), you should open the front cover before loading as described below.
1Make sure the printer is on and the roll paper cover is closed.
2Press the Paper Source button until the Sheet light comes on.
3Push the paper lever back to the released position.
Continue | ▲ |
|
2