Epson 7600 Replacing the Cutter Blade, Replacing the Maintenance Tank

Replacing the Cutter Blade

If you notice that the paper isn’t cut cleanly, you may need to replace the cutter blade. You can check its status as described below:

1Press the SelecType button on the control panel, then press until you see PRINTER STATUS.

2Press , then press until you see

SERVICE LIFE.

3Press , then press until you see CUTTER.

E*****F indicates a new cutter. If no stars are displayed, the cutter needs to be replaced.

Follow these steps to replace the cutter:

1Press the SelecType button on the control panel, then press until you see

MAINTENANCE.

2Press , then press until you see

CUTTER REPL.

3Press , then press Enter. The carriage moves to the cutter replacement position.

4Open the front cover. Hold down the side pin, as shown, then turn the latch to the right.

5Carefully remove the cutter blade, being careful not to let the spring fly out.

6Insert the new cutter blade. Hold down its side pin and secure it with the latch.

7Close the printer cover. The carriage returns to the home position and the cutter replacement is complete.

Replacing the Maintenance Tank

The maintenance tank stores ink that gets flushed from the system during print head cleaning and other maintenance procedures. It is time to replace it when the Maintenance Tank light remains on. You can also check its status as shown below:

Maintenance tank light

Maintenance tank indicator (showing an empty tank)

Follow these steps to replace the tank:

1Turn on the printer. Wait until READY or PAPER OUT appears on the control panel.

Make sure the printer is on before you start.

2Pull out the maintenance tank from the side of the printer.

Do not tip the tank, or ink may spill out.

3Insert the new tank.

7