3.Check if the following network components are in the list. If they are already installed, go to “Network Software” on page 29.

The following table lists the network components required for configuring the network interface with EpsonNet Config.

EpsonNet Config’s setting screens

Necessary components

 

 

TCP/IP, SNMP (IP trap)

Internet Protocol (TCP/IP)

 

 

The following table lists the network components required for network printing.

Printing method

Necessary components

 

 

LPR printing

Internet Protocol (TCP/IP)

 

 

4.If the necessary components are not in the list, click Install to install them.

5.Double-click Internet Protocol Version 4 (TCP/IPv4) on the Local Area Connection Properties dialog box to open the Internet Protocols Version 4

(TCP/IPv4) Properties dialog box. Set the IP address, the subnet mask, etc. and then click OK.

6.Restart the computer.

The necessary components are now installed. Go to the section “Connecting the Network Interface to the Network” on page 16.

Setting Up Your System for Network Printing 13