The message “Could not complete communicating configuration data” appears when you send settings to the network interface.

Cause

What to do

This may happen when using a Run Command Prompt from the computer on

dial-up router.which EpsonNet Config is installed, and then enter the following command:

Format: >ROUTE_ADD_the IP address of the network interface_ the IP address of the computer (the under bar represents one space)

Example: >ROUTE ADD 192.168.192.168 22.33.44.55.

Unable to start EpsonNet Config with Web Browser.

Cause

What to do

 

 

You have not set the IP

Set the IP address for the network interface using

address for the network

EpsonNet Config or the printer’s control panel.

interface.

You can check the IP address by printing a

 

network status sheet, see “Printing a Network

 

Status Sheet” on page 18.

 

 

The Model Name and IP Address do not appear in the EpsonNet Config dialog box.

Cause

What to do

 

 

If a valid IP address is not set,

Set a valid IP address.

the items indicated in the

Refresh the status by selecting Refresh from the

dialog box mentioned above

View menu.

may not appear.

Increase the length of time before a timeout. To

 

 

do this, select Options from the Tool menu, and

 

then select Timeout. Note that doing so can

 

cause EpsonNet Config to slowly.

 

 

38Troubleshooting