3.Connect one end of the computer video cable to the projector’s Computer 1 (VGA) port.
4.Make sure the DVI/VGA switch on the back panel is flipped to the right, as shown. If necessary, use the tip of a ballpoint pen to slide it over.
DVI/VGA switch (slide to right)
Computer 1
Computer 2 /Component Video
R/Cr/Pr | G/Y | B/Cb/Pb H/C Sync V Sync |
5.Connect the other end of the
computer video cable to the computer’s video port.
6.Tighten the screws on the connectors.
Connecting the Mouse and Serial Cables
To use the remote control as a mouse or use the EMP Link V software, follow the steps below. This illustration shows the connections you’ll be making:
PS/2 or USB cable |
Mouse/Com port
main cable
1.Connect the round end of the main cable to the projector’s Mouse/Com port, as shown.
18Setting Up the Projector