4.Use a screwdriver to loosen the three screws holding the lamp in place. (You cannot remove these screws.)
handle 
5.Lift up the handle and pull out the lamp.
6.Gently insert the new lamp as shown below. Make sure it’s inserted securely.
Tighten the screws on the new lamp.
7.Replace the lamp cover and tighten the cover screws. (Make sure the lamp cover is securely fastened. The projector won’t turn on if the lamp cover is open.)
8.Now reset the lamp timer as described in the following section.
caution
Do not touch the glass portion of the lamp assembly. Touching the glass will result in premature lamp failure.
Maintaining and Transporting the Projector 81