Epson 8100i No image appears on the screen, You see a blue screen with the message No Signal displayed

Problems with the Image or Sound

No image appears on the screen.

■Check that the power light is green, not flashing, and the lens cover is off.

■The projector may be in sleep mode. If the power light is orange, press the Power button to turn the projector on.

■If the power was switched off and then on again, the projector may still be cooling down. Wait until the power light stops flashing and remains orange; then press the Power button again.

■Make sure the Brightness setting on the Video menu is correct. See page 64 for more information. Try selecting the Reset All setting to return all setup menus to their default values.

■Press the A/V Mute button to make sure the picture has not been turned off temporarily.

■The attached computer may be in sleep mode or displaying a black screen saver. Try pressing a key on the computer.

You see a blue screen with the message No Signal displayed.

■Make sure the cables are connected correctly, as described in Chapter 1.

■Try restarting your computer.

■If you’ve connected more than one computer and/or video source, you may need to press the Computer or Video button (on the control panel) or the Comp1, Comp2/YCbCr, or Video button (on the remote control) to select the correct source. Allow a few seconds for the projector to sync up after pressing the button.

■If you’ve connected a second computer or you’re using component video, make sure the BNC option in the Setting menu is correct. See page 69 for more information.

■Make sure the Computer 1/DVI selector switch on the projector’s interface panel is set correctly. See Chapter 1.

Solving Problems 87