Power

Freeze

A/V Mute

R/C ON

E-ZoomOFF

 

3

2

4

1

5

 

Enter

Esc

ON/OFF switch

Problems with the Remote Control

The projector doesn’t respond to remote control commands.

■Make sure the remote control is turned on.

■Make sure you are within 30 feet of the projector, and within range of the infrared receivers (approximately 30° to left or right and 15° above or below).

■The remote control batteries may not be installed correctly or may be low on power. Check the installation or replace them as described on page 12.

■Dim the room lights and turn off any fluorescents. Make sure the projector is not in direct sunlight. Strong lighting, especially fluorescent lights, may affect the projector’s infrared receivers.

■Turn off any nearby equipment that emits infrared energy, such as a radiant room heater.

You can’t control the mouse pointer with the remote control.

■Make sure the mouse cable is securely connected to both your computer’s mouse port (using the main cable) and the projector’s mouse port. See Chapter 1 for details.

■Make sure you have used the correct cable. The PS/2 mouse cable and Macintosh mouse cable look the same, but they are not identical. Check the label on the end of the cable.

86Solving Problems