Epson C82310 Table 3. Jumper settings

The tables below describe the interface conditions that can be selected using jumpers. In all cases, ON means you connect the jumper (cover both terminals), while OFF means you disconnection of the jumper.

Table 3. Jumper settings

Jumper	Function	Factory setting

J1	Fixed (See Note)
J1	Fixed (See Note)

J2	Fixed (See Note)
J2	Fixed (See Note)
J3	Fixed (See Note)
J3	Fixed (See Note)
J4	Fixed (See Note)
J4	Fixed (See Note)
JG	ON: Connect chassis ground to signal		OFF
	ground

Note

Jl,J2,J3, and J4 jumpers are connected at the factory; do not change these setting.

Contents

Page FCC COMPLIANCE STATEMENT FOR AMERICAN USERS Page TABLE OF CONTENTS INTRODUCTION About this guide SETTING THE CONDITIONS Card layout DIP switch and jumper settings Caution DIP switches DIP switch 1 (interface operations) Table 1. DIP switch Note Switch Table 2. Switch Jumpers Table 3. Jumper settings DATA ENTRY About data entry SELF TEST SPECIFICATIONS Interface timing Figure 3. Interface timing HARDWARE DESCRIPTION Table 5. Signal description and pin assignment Page Page INSTALLATION Caution