DIP switch and jumper settings

Before you install the C82310* interface, you may need to adjust DIP switch 1 and jumper settings. You can change switch 2 settings after you install the interface.

When making DIP-switch setting changes, use a pointed device such as a ball-point pen or small screwdriver.

Caution

Always turn the power off before changing DIP-switch and jumper settings. New settings take effect when the printer is turned back on.

DIP switches

Setting DIP switches allows you to change interface functions. The two sets of switches are labeled SW1 and SW2. SW1 contains several individual toggle-type switches that can be set either on or off. The individual switches are referred to by set (SW1) and number. For example the switch in set SW1 marked by the small number 3 is called DIP switch 1-3.

5