Installing the fax board in your printer

After you have set the DIP switches, install the fax board in your printer following the instructions in your printer manual. See the section on installing an optional interface board.

Connecting the board

After you have installed the board, connect the phone cable included with the board to the connector labeled LINE on the board. Plug the other end into a standard modular-type telephone connector (jack). If you wish, you can also plug a telephone into the connector labeled PHONE.

Manual Reception

to Phone Line to Telephone

Serial Interface

Button

 

 

Performing a self test

After you have installed the fax board in your printer, perform a self test by following the steps below:

1.While holding down the manual reception button on the fax board, turn on the printer.

2.Release the manual reception button when the printer’s FEED indicator starts blinking.

The printer then prints a two-page self test. This shows that the board is properly installed and gives you information about the board and its settings.

setup 7