If normal operation is suspended for any reason, the Ethernet Card enters an error state (red and green status lights are lit). To obtain a printout describing the error, press the Status Sheet/Error Resume button once. After printing the report, the card returns to its normal operating mode (green status light is lit).
Note:
if the status sheet does not print, first make sure that the printer is on line. If it is on line but the status sheet still does not print, you will have to reset the printer by turning it off and back on. After turning off the power, wait at leastfive seconds before turning it back on; otherwise you may damage the printer.
Report printing is available after the printer is turned on and has completed its initialization routine. The Status Sheet/Error Resume function is not available under the following conditions:
Cl The printer is off line or not ready
Cl The printer has started printing
Under normal operating conditions, the status sheet will print in one of the following emulation modes:
Using the EPSON PostScript card
If your printer has an EpsonScript (PostScript) card installed, allow about a minute for the printer to initialize before trying to install or configure the Ethernet Card on the network. The Ethernet Card may not respond if initialization has not been completed.
Network installation
See the appropriate chapter in this guide for instructions on installing the card on a specific network.