Selecting PostScript

For EPL-4000/4100 and ActionLaser users

1.Hold down the SelecType button for several seconds until the display shows SelecType LEVEL2.

2.Press the Aor vbutton until the “MODE ASSIGN” menu appears.

3.Press the bbutton to enter the option; the CH submenu (for

example, $ CH P LQ>) appears.

4. Press the Aor vbutton to choose the interface that will use the PostScript CARD. (If your desired interface is displayed in step 3, ignore this step).

5.Press the bbutton to enter the printer mode option. You see

the + icon, which means the displayed printer mode is currently selected.

6.Press the Aor vbutton until the “0 PS” option appears.

7.Press the bbutton to set the PostScript mode.

8.Press the SelecType button three times to exit SelecType.

The PostScript mode remains in effect until you change the setting or turn off the printer. If you wish to make this setting permanent, use the “P-CONFIG. SAVE” menu in SelecType Level 2. See your printer manual.

1-4 Handing the PostScript CARD