Epson Stylus CX7000F Series

5.If you want borderless photos (printed without a white border), press the Copy button again to select Fit to Page mode. (If you select 100%, photos are printed with a

border.) The display changes to Copies:1 FitPage this:

6.To make multiple copies (up to 99), press the number keys on the numeric keypad. The display shows the number you select.

Note:

To exit Copy mode, press the y Cancel/Back button.

7.Press the paper type button to select Photo Paper.

8.Press the paper size button to select Letter, 4"× 6", or

5"× 7".

9.To make a color copy, press the x Start Color/OK button.

To make a black and white copy, press the x Start B&W button.

Printing appears on the display and the CX7000F Series starts copying.

If you need to stop copying, just press the y Cancel/Back button. Do not pull out paper that is being printed; it will be ejected automatically to the output tray.

Note:

The copies may not be exactly the same size as the original.

When making a lot of copies, it is a good idea to remove the printed copies from the output tray after every 10 sheets or so.

Making a Quick Copy

If you want to make a copy quickly and do not need high quality, you can print a “draft” copy. The print quality is reduced, but the copy is printed faster.

1.Load plain, letter-size paper and select Plain Paper and Letter size on the control panel.

2.Press the Copy button. If you want your copies automatically reduced or enlarged to fit the loaded paper size, press the Copy button again to select Fit to Page mode.

3.When you are ready to copy, press and hold the y Cancel/ Back button, then press and hold the x Start Color/OK button (to copy in color). When you see Color Draft Mode on the display, release both buttons. Printing appears on the display.

To make a black and white copy, press and hold the

y Cancel/Back button, then press and hold the x Start B&W button. When you see B/W Draft Mode on the display, release both buttons. Printing appears on the display.

Printing From a Memory Card

Inserting the Memory Card

1.Make sure the CX7000F Series is turned on.

2.Open the memory card door.

3.Make sure the memory card access light is off and that no cards are in any of the slots. Then insert your card into the correct slot. The memory card access light flashes and then stays on.

Insert just one card at a time

Left slot

Right slot

Memory card access light

10/06

7