Epson D28402R, D28112 Assembly And Adjustments, Rotating the Gear Case, Accessories, English

English

FIG. 1

C

D28402

D28402N

F

D28110

D28112

S

I	A	K
	B	J
		(D28402)

L

L K

G

H

K

ASSEMBLY AND ADJUSTMENTS

ATTACHING SIDE HANDLE
The side handle (E) can be fitted to either	E

side of the gear case in the threaded holes, as shown. Before using the tool, check that the handle is tightened securely. Use a wrench to firmly tighten the side handle.

Rotating the Gear Case

Turn off and unplug tool before making any adjustments or removing or installing accessories. Before reconnecting the tool, depress and release the trigger switch to ensure that the tool is off.

1. Remove guard and flanges from tool.

2. Remove the four	corner screws
attaching the gear case to motor
housing.	90˚	90˚

3.Separating the gear case from motor housing not more than 1/4", rotate the gear case head to desired position.

NOTE: If the gear case and motor housing become separated by more than 1/4", the tool must be serviced and re-assembled by a DEWALT service center. Failure to have the tool serviced may cause brush, motor and bearing failure.

3.Re-install screws to attach the gear case to the motor housing. Tighten screws to 18 in./lbs. torque. Overtightening could cause screws to strip.

Accessories

It is important to choose the correct guards, backing pads and flanges to use with grinder accessories. See pages 6–7 for infor- mation on choosing the correct accessories.

5