Epson D28112, D28402R Sanding Discs, 4-1/2 Sanding Flap Discs, 4-1/2 Cutting Wheels, English

4-1/2" Cutting Wheels

Sanding Discs 4-1/2" Sanding Flap Discs

English

Type 1 guard

backing flange

abrasive cutting wheel

clamp nut

Type 1 guard

backing flange

diamond cutting wheel

clamp nut

rubber backing pad

sanding disc

threaded clamp nut

Type 27 guard

hubbed sanding

flap disc

Type 27 guard

backing flange

non-hubbed sanding

flap disc

threaded clamp nut

1.	Open the guard latch (M). Align
		N
	the lugs (N) on the guard with the
	slots (O) on the gear case.
2.	Push the guard down until the
	guard lugs engage and rotate	O
	freely in the groove on the gear
	case hub.		M

3.With the guard latch open, rotate

the guard (I) into the desired working po sition. The guard body should be posi- tioned between the spindle and the operator to provide maximum operator protection.

4.Close the guard latch to secure the guard on the gear case. You should not be able to rotate the guard by hand when the

latch is closed. Do not operate the grinder with a loose guard or the clamp lever in open position.

5. To remove the guard, open the guard latch, rotate the guard so that the arrows are aligned and pull up on the guard.

NOTE: The guard is pre-adjusted to the diameter of the gear case hub at the factory.

If, after a period of time, the guard becomes P loose, tighten the adjusting screw (P) with clamp lever in the closed position.

I

7