Epson D28402R, D28112 4-1/2 Grinding Wheels, Wire Wheels, Mounting Guard, English

4-1/2" Grinding Wheels

Wire Wheels

Type 27 guard

backing flange

Type 27 guard

Type 27 hubbed wheel

Type 27 guard

3" wire cup

brush

Type 27 guard

4" wire wheel

English

Type 27 depressed

center wheel

threaded clamp nut

Mounting Guard

MOUNTING AND REMOVING GUARD (D28112, D28402, D28402N)

CAUTION: Turn off and unplug the tool before making any adjustments or removing or installing attachments or acces- sories. Before reconnecting the tool, depress and release the paddle switch to ensure that the tool is off.

WARNING: Accessories must be rated for at least the speed recommended on the tool warning label. Wheels and other acces- sories running over rated accessory speed may burst and cause injury. Threaded accessories must have a 5/8"-11 hub. Every unthreaded accessory must have a 7/8" arbor hole. If it does not, it may have been designed for a circular saw and should not be used. Use only the accessories shown on pages 6–7 of this man- ual. Accessory ratings must be above listed minimum wheel speed as shown on tool nameplate.

CAUTION: Guards must be used with all grinding wheels, sanding flap discs, wire brushes, and wire wheels. The tool may be used without a guard only when sanding with conventional sanding discs. Some DEWALT models are provided with a guard intended for use with depressed center wheels (Type 27) and hubbed grinding wheels (Type 27). The same guard is designed for use with sanding flap discs (Type 27 and 29) and wire brushes. Grinding and cutting with wheels other than Type 27 and 29 require different accessory guards not included with tool. Mounting instructions for these accessory guards are included in the acces- sory package.

6