Attention
•
If an incorrect password is entered three times in succession, the message "The
projector's operation will be locked." is displayed for about five minutes, and
then the projector switches to standby mode. If this happens, disconnect the
power plug from the electrical outlet. Wait for approximately 30 seconds
leaving the projector unplugged, and then plug it back in and turn on the
projector. The projector displays the Password entry screen again so that you
can enter the correct Password.
•
If you have forgotten the password, make a note of the "Request Code: xxxxx"
number that appears on the screen and contact the nearest address provided in
the Support and Service Guide.
s
Epson Projector Contact List
•
If you continue to repeat the above operation and input the wrong Password
thirty times in succession, the following message is displayed and the projector
does not accept any more Password entries."The projector's operation will be
locked. Contact Epson as described in your documentation."
s
Epson
Projector Contact List
Restricting Operation (Control Panel Lock)Perform one of the following to lock the operation buttons on the Control
panel.
•Full Lock
All of the buttons on the Control panel are locked. You cannot perform
any operations from the Control panel, including turning the power on or
off.
•Partial Lock
All of the buttons on the Control panel, except for the [t] button, are
locked.
This is useful at events or shows when you want to deactivate all buttons
and only project, or at schools when you want to limit button operation.
The projector can still be operated using the Remote Control.
Procedure
A
During projection, press the [Menu] button and select Settings
- Control Panel Lock from the Configuration Menu. s "Using
the Configuration Menu" p.48
Using the Remote Control Using the Control panel
B
Select either "Full Lock" or "Partial Lock".
C
Select Yes when the confirmation message is displayed.
The Control panel buttons are locked according to the setting you
chose.
Security Functions
39