Setting the Diskette Drive(s)

On your system, diskette drive A is the 3.5-inch highdensity drive installed in the lower drive bay on your system. You may also have another drive of a different size or capacity; this is drive B. Check the settings for both drives and correct them if necessary.

Note

If you add a diskette drive and want to reassign the top drive as drive A, you must change jumpers J17 through J20, as described in Chapter 3. Then run SETUP to reassign drive

types.

Setting the Hard Disk Drive(s)

The SETUP program lets you select the type of hard disk drive(s) installed in your computer. If your system was configured for you, the hard disk drive type has been preset. To set the hard disk drive type, follow these guidelines:

QIf your system does not have a hard disk, select

Not Installed for Hard Disk 1 and Hard Disk 2.

PIf your computer came with an Epson-installed hard disk drive, you need to define your own drive type. For more information, see ‘Defining your own drive type” on page 1-14.

PIf you have installed another type of hard disk drive, you need to select the drive type number that matches your drive.

Setting Up Your System 1-11