Using Continuous Paper

See page 2-15for instructions on loading paper with the rear-push tractor.

To remove the tractor unit, press the tractor’s lock tabs, tilt the unit back, and lift it off the printer.

Installing the pull-tractor

You can also use the tractor unit as a pull-tractor. To do this, you remove the paper-tension unit and install the tractor unit in its place. Follow the steps below to install the pull-tractor:

1.Make sure the power is turned off. Lift the printer cover and paper guide up and off the printer.

2.Grasp both ends of the paper-tension unit and lift it up and off the printer. Store the paper-tension unit in safe place.

3.An arrow on each side of the mounting slots shows you where to install the tractor. While pressing in the tractor’s lock tabs, tilt the tractor unit forward and lower it straight down into the slots.

See page 2-18for instructions on loading paper with the pull- tractor.

To remove the tractor unit, press the tractor’s lock tabs, tilt the unit back, and lift it off the printer. Then replace the paper tension unit.

Paper Handling 2-11