5.After you set the tear-off position, press the Pause button to turn off the Micro Adjust mode.
6.Tear off the printed page(s).
When you resume printing, the printer automatically feeds the paper back to the top-of-form position.
Printing on Single Sheets
You can load single-sheet paper one sheet at a time using the printer’s paper guide. The printer accommodates single sheets from 3.9 to 10.1 inches (100 to 257 mm) wide.
Before printing on single-sheet multipart forms, envelopes, or other special paper, be sure to the set the paper thickness lever to the appropriate position. See “Adjusting the Paper Thickness Lever” on page 12 for details.
To load a stack of single-sheet paper, use the optional cut-sheet feeder.
You can use the paper guide to load single-sheet carbonless multipart forms that are fastened at the top by line gluing. Insert multipart forms in the paper guide, bound edge first and printable side down.
Loading Single Sheets
1.Make sure the paper-release lever is pushed back to the single-sheet position, as shown below. Raise the paper guide upright.
2.Slide the left edge guide until it locks in place at the guide mark, then adjust the right edge guide to match the width of your paper.
3.Slide a sheet of paper down firmly between the edge guides until it meets resistance.
Printing on Special Paper
The printer accommodates multipart forms, labels, and envelopes. For multipart forms and labels, you should not print any closer than 0.5 inch or 13 mm from either side of the paper.
When printing on multipart forms, thicker-than-normal paper, labels, or envelopes, make sure your software program settings keep the printing entirely within the printable area. Printing past the edge of these papers can damage the print head.