EPSON
7.Slide the left sprocket unit so that its sprockets match the position of the holes in the paper and lock the unit in place. Then slide the right sprocket unit to match the width of your paper, but do not lock it. Move the paper support midway between the two sprocket units.
8.Open the sprocket covers, fit the first holes of the paper over the sprocket pins, and then close the sprocket covers. Slide the right sprocket unit to remove any slack in the paper and lock it in place.
9.To separate the incoming paper from the printed paper, attach the paper guide. Hold it horizontally and fit its notches over the printer’s mounting posts. Then slide the paper guide toward the back of the printer until it clicks.
10.Attach the printer cover and adjust the paper position with the
11.Make sure the printer cover is closed, but with the paper guide cover open.
If you want to change the position where printing begins on the page, press LF/FF to advance the page to the next
To eject the paper, tear off the paper entering the printer; then press the LF/FF button to feed the paper forward.
Adjusting the Top-of-Form Position
The
Never use the knob to adjust the
Your
The top margin setting made in some application software overrides the
1.Make sure the printer is turned on and paper is loaded.
2.Remove the printer cover.
3.Hold down the Pause button for about 3 seconds. The Tear Off lights start flashing and the printer enters the Micro Adjust mode.
4.Press the LF/FF D button to move the
plastic ribbon cover
The printer has a minimum and maximum
When the paper reaches the default
5/00 | EPSON |