4.Position one of the memory chips over the socket as shown below, aligning the pins on the chip with the holes in the socket. Make sure the small notch on the end of the chip aligns with the corresponding notch in the socket.

5.Gently press the chip halfway into the socket (to make sure it is correctly aligned). If the chip does not go in smoothly, remove it and try again.

6.When the chip is properly positioned, push down firmly on both ends to make sure it is well-seated.

7.Repeat steps 4 through 6 for each of the remaining chips.

8.Replace any option cards you removed. See page 3-13 for instructions.

3-18 Installing and Removing Options