Calibrating the Status Gauge
The gauge readings may deviate slightly from the set positions over time. If this happens, follow the steps below to calibrate the gauge needles.
1.Press 
(LCD) then 
(MENU) to display the Main menu on the LCD monitor.
2.Select 
(Settings), 
(Basic Setup), then Calibrate Needles
using the jog dial, then press 
(ENTER).
3.Select the needle you want to calibrate using the jog dial, then press 
(ENTER).
Needle Calibration Please calibrate carefully.
Finish
S e lect | B a c k |
4.Select l or r using the jog dial, then press 
(ENTER) repeatedly to adjust the needle position on the status gauge.
5.Select Finish using the jog dial, then press 
(ENTER).
6.Repeat steps 2 through 4 if you want to calibrate the other needles.
7.Select Finish using the jog dial, then press 
(ENTER).
Formatting the Memory Card
Format the memory card when you want to erase all the data on the card, or if the memory card has been formatted with a computer or another digital camera and you cannot save any images on the card. Follow these steps:
1.Press 
(LCD) then 
(MENU) to display the Main menu on the LCD monitor.
2.Select 
(Settings) then 
(Format SD Card) using the jog dial, then press 
(ENTER).
3.Select Quick Format or Full Format using the jog dial, then press
(ENTER). The confirmation screen is displayed.
4.Select OK using the jog dial, then press 
(ENTER).
The formatting starts and the message “Formatting...” is displayed.
After the memory card is formatted, the screen returns to the Settings menu.
Note:
❏When you format the memory card, all the data on the card will be lost, including the locked images.
❏If the memory card is locked, the message “Cannot format. The SD card is