Epson MF1436-02, S5U1C63000H2 2.5 Setting the Dip Switch, — OPEN—, <Setting baud rate, <Setting the self diagnostic function

CHAPTER 2: S5U1C63000H2 PACKAGE

2.5 Setting the Dip Switch

The S5U1C63000H2 works with a personal computer that runs Windows as a host. With a general computer that meets the condition, the serial transfer rate set at the factory (9600 bps) is good for use. In case the rate is changed, the transfer rate between the host computer can be changed by this switch. The switch also sets a self diagnostic function, which is equipped in the S5U1C63000H2, working or not working at the power on. Figure 2.5.1 shows the dip switch.

— OPEN—

1 2 3 4 5 6 7 8

					Fig. 2.5.1 Dip switch
<Setting baud rate>
	SW1–3	SW4	SW5	SW6	Baud rate setting
	OPEN	OPEN	OPEN	OPEN	9600 bps, 8-bit character, 1 stop bit, no parity (factory setting)
	OPEN	OPEN	ON	ON	2400 bps, 8-bit character, 1 stop bit, no parity
	OPEN	ON	OPEN	ON	4800 bps, 8-bit character, 1 stop bit, no parity
	OPEN	OPEN	OPEN	ON	19200 bps, 8-bit character, 1 stop bit, no parity
	OPEN	ON	ON	OPEN	38400 bps, 8-bit character, 1 stop bit, no parity
	Other settings				Do not set.

Note: The setting at the host end is recommended to be "9600 bps, 8-bit character, 1 stop bit, no parity".

<Setting the self diagnostic function>

SW8	Setting
OPEN	Self diagnosis On
ON	Self diagnosis Off (factory setting)

Note: When the S5U1C63000H2 is started with the self diagnosis on, it takes approx. 5 minuets to be ready for use.

Open means that the switch lever is at upper side.

On means that it is at lower side.

6	EPSON	S5U1C63000H2 MANUAL
		(S1C63 FAMILY IN-CIRCUIT EMULATOR)