CHAPTER 3: CONNECTION
3.4 Installing Peripheral Circuit Board (S5U1C63xxxP)
By installing the S5U1C63xxxP peripheral circuit board (to be separately sold) into a slot of the S5U1C63000H2, a debug system can be made corresponding to each device of the S1C63 Family. Figure
3.4.1shows installing method of the peripheral circuit board. The S5U1C63000H2 is equipped with a main control board and a LCD drive board.
(1), (4)
(2)
Peripheral circuit board(2), (3)
Fig. 3.4.1 Installing method of the peripheral circuit board
(1)Unfasten the screws located on the left and right sides of the front panel of the S5U1C63000H2 by turning them counterclockwise, then remove the front panel.
(2)Insert the peripheral circuit board into the uppermost slot and push it using the jig attached with the S5U1C63000H2 as shown in Figure 3.4.2.
Using this jig as a lever, push it toward the inside of the board evenly on the left and right sides. After confirming that the peripheral circuit board has been firmly fitted into the internal slot of the S5U1C63000H2, remove the jig.
(3)Dismounting peripheral circuit board Set the jig into position as shown in Figure 3.4.3. Using this jig as a lever, push it toward the outside of the board evenly on the left and right sides and pull the peripheral circuit board out of the S5U1C63000H2.
(4)Mounting the front panel
Mount the front panel removed at the step (1) on the main case by pushing and turning two screws located at both side.
Peripheral circuit board
Fig. 3.4.2 Installing the peripheral circuit board
Peripheral circuit board
Fig. 3.4.3 Dismounting the peripheral circuit board
(5) The jig has a magnet for keeping under the bottom plate of the case while not in use.
8 | EPSON | S5U1C63000H2 MANUAL |
|
| (S1C63 FAMILY |