Epson TX101 Do not damage the Pinion Gear, Be careful of not to break the soldered portions

Epson STYLUS NX100/NX105/SX100/SX105/TX100/TX101/TX102/TX103/TX105/TX106/TX109/ME 300 Revision A

CAUTION „ Do not damage the PF Roller Gear.

„	Do not damage the Pinion Gear.
„	Be careful of not to break the soldered portions.

5.Remove both the screws that secure the PF Motor.

6.Remove the PF Motor pulling out the shaft of the motor through the notch of the Bracket.

3.	Remove the screw that secures the Bracket.
4.	Release the Bracket from the dowels of the Lower Housing, and remove the
	Bracket and the PF Motor while pulling out the PF Motor Cable (see
	Fig.4-67.)through the hole of the Lower Housing.

PF Motor

PF Roller Gear

Pinion Gear

PF Motor

Bracket

Pinion Gear

SCREW SEMS M2.6x3.5 PAN HEAD+ (3.5±0.25kgfcm)

Notch

Bracket

Positioning Hole and Dowel

Screw it with the

Grounding Wire.

SCREW M3x8 P-TITE (5±0.5kgfcm)

Figure 4-69. Removing the PF Motor (3)

ADJUSTMENT REQUIRED

Figure 4-70. Removing the PF Motor (4)

„When installing the PF Motor, insert the black cable over the red one. (See Fig.4-70.)

„Install the Grounding Spring as follows: (See Fig.4-68.)

1.Insert the tip of the spring to the hole of the Lower Housing.

2.Attach the eyes of the spring to the hook of the Main Frame and that of the Bracket to secure it.

„Before securing the Bracket, align the four positioning holes of it with the four dowels of the Lower Housing. (See Fig.4-69.)

„Don not damage the PF Roller Gear and the Pinion Gear.

„Route the PF Motor Cable following the procedure below. (See Fig.4-67.)

1.When pulling out the cable from the hole of the Lower Housing, give the cable some slack to prevent breaking the soldered portions.

2.Route the cable through the rib.

Whenever the PF Motor removed/replaced, the required adjustments must be carried out.

•Chapter 5 “ ADJUSTMENT” (p.100)

DISASSEMBLY/ASSEMBLY Disassembling the Printer Mechanism 83

Confidential