1.3 Printer Installation
The following will guide you through the installation of your P420 printer.
CAUTION : Limit AC power supplied to the P420 Printer to 110 - 230 V AC, 60 - 50 Hz for an associated 680 mA - 310 mA. Limit excess current draw to 16 amps or less, using an associated cir- cuit breaker or other such device. Never operate the printer in a location where operator, computer, or printer can get wet. Personal injury could result. The printer must be connected to an earthed electrical power supply and properly protected against electrical surges and grounding faults.
1. Place the printer in a location that allows easy access to all sides. The printer should never be operated while resting on its side or upside down.
2. Place the printer’s power switch in the OFF
(0)position.
3.Insert the power cable to the printer power socket and attach to grounded electrical socket of the
proper voltage and type.
4. Attach interface cable to printer and computer and then secure.
5.Switch power on.
CAUTION: Intermittent or unpredictable operation may occur from unsecured connectors. If damaged, the power cable must be replaced by an exact equivalent.
Use only Parallel Cable under 3 Meters in length.
4 | GETTING STARTED |
