Maytag 61005299 warranty Installation, Location, Energy Saving Tips, Leveling

Installation

Your new refrigerator was packed carefully for shipment. Remove and discard shelf packing clips (if used) located just above each shelf where they hook onto the frame. To remove plastic clips wiggle the clips sideways and pull straight out.

Location

•Allow for a free flow of air through the front base grille.

•Install the refrigerator where the room temperature will not go below 55˚ F. With temperatures below 55˚, the refrigerator will not run frequently enough to maintain proper temperature in the freezer.

•Allow a minimum 1/2” clearance on the sides, top and back for ease of installation. If refrigerator is placed with the door hinge side against a wall, you may want to allow additional space so the door can be opened wider.

•Use caution when installing the unit on vinyl or hardwood floors so as not to mark or otherwise damage the flooring. A piece of plywood, a rug or other material should be used to protect the floor while positioning the unit.

Energy Saving Tips

•Locate the refrigerator away from heat producing appliances such as the range or dishwasher, heat vents and direct sunlight.

•Level the refrigerator and do not block ventilation around the front grille.

•Let hot dishes cool slightly before putting into the refrigerator or freezer.

•Cover liquids.

•Keep the freezer full to near capacity so less cold air will escape during door openings. When the freezer is less than two-thirds full, place milk cartons half full of water in the freezer.

•Wipe moisture from the outside of containers before placing them into the refrigerator.

•Avoid opening the doors too often.

Leveling

Your refrigerator is equipped with front and back rollers so it can be moved away from the wall for cleaning. To enhance its appearance and to maintain performance, your refrigerator should be level.

For refrigerator models with adjustable wheels:

•Remove the base grille by grasping both ends and pulling straight out (see fig. 1).

•Adjust the wheels with a screwdriver or a 1/4” socket (see fig. 2).

•To prevent the refrigerator from rolling, use the leveling/lock screws. Turning down both leveling screws locks the cabinet into place (see fig. 3).

•To replace the base grille, align the spring clips with the round openings in the cabinet and push each end in until the grille locks into place.

For all other models:

•Adjust the leveling/lock screws beneath each front corner at the base of the cabinet. Turn these leveling/lock screws clockwise to raise a cabinet corner and counterclockwise to lower a cabinet corner (see fig. 3).

•If the floor is not level and it is necessary to raise the rear of the cabinet, we suggest rolling the rear wheels onto a piece of plywood or other shim material.

Fig. 1

TURN CLOCKWISE TO

RAISE CABINET CORNER

	TURN
	COUNTER-CLOCKWISE
	TO LOWER CABINET
Fig. 2	CORNER

					T
			O	T	O R	A I	S	E
	L								C
W	O									B
									A
E										I
R										N
	C	A							E
								T
			B I		N
Fig. 3					E T

2