PARITY *None, Even, Odd, IgnoreFlUTOLINEFEED On, Off

DCl/DC3

Disable,

Enable
DEFfYJLT MCR#

#l, #21

#3, #4

*Displayed only when the serial interface setting is selected

The LQ-2550 comes with preset default values, which can be printed out using the PRINT GLJT SETTINGS mode. These default values are shown below.

D e f a u l t , set.t;ing

INTERFACE

P a r a l l e l

BAUD RATE

* 9 6 0 0 R P S

PARITY

* None

AUTO L,INE FEED

O f f

DCl/DC3

D i s a b l e

DEFAUI,T MACRO

#3

If your computer has a parallel interface, the preset defaults should work correctly in most cases. You may wish to change the DEFAULT MACRO settings, however, to match your usual style of printing. Here are a few additional tips on setting the defaults.

•INTERFFICE: If your computer has a serial interface, you need to change the interface setting to Serial. (If you are using an optional interface board, be sure that the interface setting is Pa r a 11 e 1, regardless of what type of interface it actually is. See the section on interface boards in Chapter 7 for more information.)

•BFllJD RfiTE, Pf?RIT’r’: Set these only if you are using the serial interface. (Be sure to first set the interface setting to Serial . BALJD RfiTE and PARITY do not display in SelecType unless the interface is set to Se r i a 1.) Check your computer manual for the correct baud rate and parity settings. Your computer and printer should be set to the same baud rate and parity.

Using the Printer

3-19