f3UTO LINE FEED: This setting should remain at its default value (0 f f ) in most cases. Most applications send automatic line feeds at the end of every line. If all of the lines are printing on top of each other, then set FIIJTO LINE FEED to On.

DC 1 /DC3: This setting should also be left at its default value (Disable) in most cases. See these codes in Chapter 8 for more information.

DEFWJLT MfKRO: This setting controls which macro is loaded when you turn on the printer.

To change and save the default settings, perform the steps listed below. The following example describes the procedure for changing the interface, baud rate, and parity for a serial interface, but all the other options can be changed in the same manner. If you are changing only one option, follow steps 1 - 4 and 13 - 17 only.

The displays shown may be different if your printer’s preset settings have been changed.

Note: Your new default settings do not take effect until you turn the printer off and then back on.

1. Select the CHfINGE DEFfWLTS mode from the SelecType main menu.

The display shows:

SCHfiNGEDEFAULTS

b

 

 

 

 

2.Activate this mode by pressing the b button directly beneath the display.

The display changes to:

SINTERFCICE

Parallel b

 

 

 

Note: If you wish to change an option other than INTERFfKE, press the A or V button.

3-20

Using the Printer