Equator EZ 2512 CEE When the new washer-dryer arrivesWhen the new washer-dryer arrives, When the new washer-dryer arrivesWhen the new washer-dryer arrives When the new washer-dryer arrives

WARNING ARNING

ARNING ARNING

ARNING

Electrical RequirementsElectrical Requirements

Electrical Requirements

Electrical Shock Hazard (death, fire or electrical shock):Electrical Shock Hazard (death, fire or electrical shock):

Electrical Shock Hazard (death, fire or electrical shock):

1) Plug into a grounded 3 prong outlet.1) Plug into a grounded 3 prong outlet.

1) Plug into a grounded 3 prong outlet.

2) Do not remove ground prong.2) Do not remove ground prong.

2) Do not remove ground prong.

3) Do not use an adapter or an extension cord.3) Do not use an adapter or an extension cord.

3) Do not use an adapter or an extension cord.

After removing the appliance from its packaging, check that it

is intact. If in doubt, contact Equator immediately. The insideThe inside

The insideThe inside

The inside

of the machine is supported, for transportation, by fourof the machine is supported, for transportation, by four

of the machine is supported, for transportation, by four

shipping bolts shipping bolts

shipping bolts on the back panel.on the back panel.

on the back panel.on the back panel.

on the back panel.

BefBef

Before using the washerore using the washer

ore using the washerore using the washer

ore using the washer-dr-dr

-dr-dr

-dryy

yerer

erer

er,,

, remoremo

remoremo

remove the eve the e

ve the eve the e

ve the externalxternal

xternalxternal

xternal

shipping bolts,shipping bolts,

shipping bolts, remove the spacers together with the rubber

tubes attached to them (save all the parts) and use the plastic

blanking plugs provided to fill in the holes. Use the wrench

provided to remove the external bolts.

Attach the two rubber hoses provided Attach the two rubber hoses provided

Attach the two rubber hoses provided to the red (hot) and

white (cold) water inlets

on the back (top right) or the appliance.

Connect the other ends to the appropriate built-in water supplies or a

Y-adapter / Faucet Adapter combination to a single source (like a kitchen

faucet.). Using the “U”-Connector provided, place the drain hose into the

drain pipe (or the sink.) See Plumbing on Page 7 for more details.

LevelingLeveling

Leveling

The washer-dryer must be levelled appropriately in order to

guarantee its correct functioning. To level the appliance, the front

feet must be adjusted; the angle of inclination, measured according

to the worktop, must not exceed 2°.

WARNING

Excessive Weight HazardExcessive Weight HazardExcessive Weight HazardExcessive Weight HazardExcessive Weight Hazard

Use two or more people to move

and install your appliance.

Failure to do so can result in

back or other injury

The front feet are self-locking & adjustable

Instructions for installation and use 66666When the new washer-dryer arrivesWhen the new washer-dryer arrivesWhen the new washer-dryer arrivesWhen the new washer-dryer arrivesWhen the new washer-dryer arrives

Installation

Whether new or just transported to a new house, installation is extremely important

for the correct functioning of your washer-dryer.

For your own protection, and to prevent accidents, injury and

fire, please read the following carefully:

1.1.

1. Destroy the carton and plastic bags, after the washer-dryer

has been unpacked.

2. 2.

2. Children should never be left alone or unattended in the

area where appliances are located.

3.3.

3. Washer installation and grounding must be done in

accordance with local codes by a qualified installer. Installation

instructions are packed in new washer to the installer’s

reference.

4. ONLY the Equator Low Sudsing detergent is recommended

for this appliance. To order your box of Equator detergent call

1-800-935-19551-800-935-1955

1-800-935-1955.

5.5.

5. The washer must be plugged into a properly grounded 3-

prong electrical outlet. For your safety, the third or round

grounding prong must never be removed.

DO NOT USE AN EXTENSION CORD.DO NOT USE AN EXTENSION CORD.

DO NOT USE AN EXTENSION CORD.

6. 6.

6. Repair or replacement of a part should be made only by a

qualified service technician to prevent personal injury or damage

to the machine. For a list of authorized repair service agents,

call Equator Service at 1-800-776-3538Equator Service at 1-800-776-3538

Equator Service at 1-800-776-3538Equator Service at 1-800-776-3538

Equator Service at 1-800-776-3538.

7. 7.

7. Disconnect power to the washer at the circuit breaker or

fuse box, or unplug the machine in an emergency when

servicing is required. Have the installer show you and label the

proper switch or fuse at the electrical disconnect box.

WARNING - ARNING -

ARNING - ARNING -

ARNING - The Appliance The Appliance

The Appliance The Appliance

The Appliance should be connected to anshould be connected to an

should be connected to anshould be connected to an

should be connected to an

Individual BrancIndividual Branc

Individual Branch Cirh Cir

h Cirh Cir

h Circuit with N.cuit with N.

cuit with N.cuit with N.

cuit with N. 14 A 14 A

14 A 14 A

14 AWG WG

WG WG

WG Wire andWire and

Wire andWire and

Wire and

Protected by 15 A Fuse.Protected by 15 A Fuse.

Protected by 15 A Fuse.

GROUNDING INSTRUCTIONSGROUNDING INSTRUCTIONS

GROUNDING INSTRUCTIONS

This appliance must be grounded. In the event of malfunction,

or breakdown, grounding will reduce the risk of electric shock

by providing a path of least resistance for electric current. This

appliance is equipped with a cord having an equipment-

grounding conductor and grounding plug. The plug must be

plugged into an appropriate outlet that is properly installed and

grounded in accordance with all local codes and ordinances.

WARNING - ARNING -

ARNING - ARNING -

ARNING - Improper connection of the equipment-grounding

conductor can result in a risk of electric shock. Check a qualified

electrician if you are in doubt as to whether the appliance is

properly grounded.

Do not modify the plug provided with the appliance. If it will not

fit the outlet, have a proper outlet installed by a qualified

electrician.

Retain the shipping bolts, spacers and washers.Should you move residence then these should bereplaced to support the inside of the machine toprevent damage when transporting the machine.

Warning !

The company denies all liability if and when theseinstructions are not respected. Plastic bags,expanded styrofoam, nails and other packagingparts are not children’s toys, are potentiallydangerous and should be disposed off properly.