10)Fusible Link / Wire with fuse (00807) Replacement Procedure:
▪
▪
▪
▪
▪
▪
Unplug the unit.
Remove the top panel (Two screws behind and slide back)
The fusible link is located on the heater housing as shown in the figure.
There is a small fuse inside the covering held by the clamp crewed on the housing. Unfix the screw and replace the same and do the wiring as before / below.
Fix all the parts back by following the reverse procedure.
Wiring: Fusible Link
Remove blower fan connector
Remove clamp screw with Philip Screw driver
Fusible link
Remove heater connector
Testing Procedure:
▪Cold Test:
1)Check the continuity between the two terminals of the fusible link, if there is continuity the fusible link is good.
21
