User Instructions
Combination Detergent & Rinse Aid Dispenser
Detergent Dispenser
Fill the dispenser with detergent unless selecting a Rinse & Hold program. Gently close the lid. The detergent will be dispensed automatically during the wash cycle.
Selecting the Correct Amount of Detergent
Fill the large compartment of the dispenser with approximately ONE tablespoon of detergent for all programs.
When running Pots & Pans Wash also place an additional ONE tablespoons or so of detergent to the small compartment of the dispenser.
Remember, less than the recommended amount of detergent is required if the dishwasher is connected to a soft water supply.
Never sprinkle detergent directly onto tableware. Always use a detergent made specifically for automatic dishwashers.
Rinse Aid Dispenser
Use Rinse Aid in the dishwasher to obtain the best possible drying result while eliminating water spots on your tableware and glassware. The automatic Rinse Aid Dispenser releases a measured quantity of Rinse Aid into the final Rinse segment of each wash program.
Filling the Rinse Aid Dispenser
To fill the liquid Rinse Aid dispenser, follow these steps:
1.Open Dispenser «A».
2.Pour the liquid into opening «B» and, without allowing it to overflow, fill the dispenser.
3.Close the Dispenser.
Always wipe away any drops that may have spilled outside the dispenser.
Amount to use
For optimum performance, each wash program, except Rinse & Hold, requires a certain amount of Rinse Aid be dispensed. The dispenser is factory preset to automatically dispense 0.07 ounce of liquid per wash program. Depending on the quality of water, it may be necessary to adjust the amount dispensed.
To check whether or not the Rinse Aid dispense volume is properly set, examine your tableware and glassware following a completed wash program:
•Increase Setting, if there are dried water spots on the surface of these items.
•Decrease Setting, if there are traces of water on these items.
Adjusting Rinse Aid Dispense Setting
The dispenser has a CONTROL "C" which regulates the amount of Rinse Aid dispensed. Rotate the plug in the container to the position required to adjust the dosage. The numeric dosage setting corresponds directly to the volume of rinse aid dispensed. eg. When the control is pointing at the number " 2 " the dispenser will emit 0.07 ounce of rinse aid in the final rinse segment of each wash program.
Rinse Aid Liquid Level
There are two indicators to let you know when the Rinse Aid Dispenser requires filling:
1.Control Panel Light Indicator - As a convenient reminder, an indicator light on the control panel will illuminate whenever the Rinse Aid Dispenser is empty and requires refilling.
2.Transparent
Note: A full dispenser set to dispense level " 2 " should yield approximately 60 wash programs before refilling becomes necessary.
Buttons
When buttons are in the “IN” position, they are OFF. Push buttons out to activate functions.
8
