The FWT is also equipped with a USB port that enables you to use it as a GSM modem. This enables PC fax and for data transfers as well as SMS services.
Note: When making the connections, the
Tip: If your home or company is already wired with telephone cable, you only need to connect the cable to the FWT RJ11 con- nector and your telephone line will be up and running in all rooms.
Note: The telephone wire must be installed indoors.
Note: The telephone wire should not exceed 600 meters.
Checking the connections
Once the devices (1 up to 3) have been connected, do the Ring Back Test as described below in order to check the connections:
•Lift one telephone and dial **#10#. You will hear a beep tone and the terminal LEDs will start flashing. Three flashes indicate it is syn- chronized.
•Hang up the telephone and check that all the connected telephones start to ring.
•Lift any of the telephones connected and then hang up again. The ringing will stop and the LEDs will return to normal operation mode.
Tip: If any of the telephones are not ringing, check your tele- phone cable layout and connections to make sure that all devices are properly connected.
Checking the quality of the calls
Use any of the telephones connected to the FWT terminal to make a call. Check the speech quality and ask the receiver to call you back to confirm that you can also receive calls.
If you have problems, please refer to the topic Troubleshooting docu- mented on page 61 for more detailed information.
Installing the FWT as a telephone line
The FWT is designed to provide a telephone line (RJ11 connector) to which up to three (3) Fixed Line devices can be connected in parallel. The FWT provides a single telephone line, which means that only one
Fixed Wireless Terminal: G32 & G36 | 17 |
