USER GUIDE
•
Changing Printer Paper & Ribbon
Printer Paper Role Replacement
The ChartReader uses standard 57mm wide paper or 2 layer 57mm wide NCR type duplicating paper.
To replace the paper roll perform the following steps:
! | NEVER PULL PAPER BACKWARDS THROUGH PRINTER MECHANISM AS |
IRREPARABLE DAMAGE WILL RESULT! |
n o
Open the hinged lid by springing the plastic clip at the rear of the case and lift the lid open.
Remove the short length of paper remaining in the printing mechanism by:
zusing the small FEED button 
located on the circuit board to the left of the printer mechanism, or
zusing the manual wheel (if present), or
zgently pulling the paper through the mechanism by hand in normal direction.
Feed through
Approx 6mm
Ribbon Cassette
PAPER LOADING PATH
pRemove old roll core from the holding fingers and insert the new roll with the paper direction as shown in the diagram above.
qFree the end of the new paper and ensure that the end is cut reasonably straight and square. Trim with scissors if necessary.
rTake the free end of the paper and gently push it over the plastic ramp and into the mouth of the printer .
sBy using the manual feed knob (if present) or the FEED button (with power ON), feed the paper through the mechanism, past the ink ribbon and leave about 6mm (¼ inch) of paper protruding from the top of the mechanism.
tTighten the ink ribbon in it's cassette by turning the star shaped disc (on the left of the cassette) 2 or 3 turns clockwise.
uClose the case lid making sure the paper feeds through the gap in the lid and secure the lid catch.
♥ Escort Data Logging Systems LTD | DATED: 03/07/07 | PAGE 13 |
