Esoteric SA-50 Before Use, What’s in the box, Read this before operation, When Moving This Unit

Before Use

What’s in the box

Please confirm that the following accessories are in the box when you open it.

Power cord x 1

Remote control unit (RC-1156) x 1

Batteries (AA, R6, SUM-3) x 2

Felt pads x 3

Owner’s manual x 1

Warranty card x 1

Read this before operation

<Place the unit in a stable location near the audio system that you will use.

<Be careful to avoid injury when moving the unit due to its weight. Get someone to help you if necessary.

<As the unit may become warm during operation, always leave sufficient space around the unit for ventilation. Make sure there is at least 20 cm (8”) of space above and at least 5 cm (2”) of space on each side of the unit. Do NOT place anything such as a CD, CD-R, LP, cassette tape etc. on top of the unit.

<The voltage supplied to the unit should match the voltage as printed on the rear panel. If you are in any doubt regarding this matter, consult an electrician.

<Choose the installation location of your unit carefully. Avoid placing it in direct sunlight or close to a source of heat. Also avoid locations subject to vibrations and excessive dust, heat, cold or moisture.

<Do not open the cabinet as this will void your factory warranty and might result in damage to the circuitry or electrical shock. If a foreign object should get into the unit, contact your dealer or service company.

<When removing the power plug from the wall outlet, always pull directly on the plug, never yank on the cord.

<Keep this manual in a safe place for future reference.

Do Not Move the Unit During Playback

During playback, the disc rotates at high speed. Do NOT lift or move the unit during playback. Doing so may damage the disc or the unit.

When Moving This Unit

When changing places of installation or packing the unit for moving, be sure to remove the disc and return the disc tray to its closed position in the player. Then, press the power switch to turn the power off and disconnect the power cord. Moving this unit with the disc loaded may result in damage to this unit.

Placement of the unit

High-quality hardened tool steel is used for the pin-point feet, securely attached to the bottom of the unit. Although the outer feet may appear loose, the weight of the unit causes them to become firm and secure. The design effectively damps and reduces vibration.

<To protect the supporting furniture surface, you may stick the felt pads supplied with the unit to the bottom of the metal feet.

Pin-point foot

Bottom plate of

Steel foot the unit

Cover foot Cover foot retaining screws

4