Essick Air 14 DD Troubleshooting Guide, Limited Warranty, Problem, Possible Cause, Remedy, 110525

Troubleshooting Guide

Problem		Possible Cause		Remedy
Failure to	1.	No electrical power to unit	1. Check power
start or no	• Fuse blown		•	Replace fuse
air delivery	• Circuit breaker tripped		•	Reset breaker
	2.	Belt too loose or tight	2. Adjust belt tension
	3.	Motor overheated	3. Determine cause of over-
				heating
	• Belt too tight		•	Adjust belt tension
	• Blower bearings dry		•	Oil blower bearings
	• Motor bearings dry		•	Oil motor bearings
	• Motor pulley diameter too		• Adjust pulley to correct
		large		diameter
	4.	Motor locked	4. Replace motor
Inadequate	1.	Insufficient air exhaust	1. Open windows or doors
air delivery				to increase air flow
with cooler	2.	Belt too loose	2. Adjust belt tension or
running				replace if needed
	3.	Pads plugged	3. Clean pads
	4. Insufficient water flow		4. Clean water distribu-
		over pads		tion system and trough
				openings
Musty or	1.	Stale or stagnate water in	1. Drain pan and clean
unpleasant		cooler		pads
odor	2.	Pads not wetting properly	2. Check water distribution
				system
	• Trough holes clogged		•	Clean
	• Pump not working prop-		• Replace or clean pump
		erly		(Unplug)
	• Insufficient water flow		• Clean distribution sys-
		over pads		tem and trough open-
				ings

Problem		Possible Cause		Remedy
Motor	1.	Low voltage	1.	Check voltage
cycles on	2.	Excessive belt tension	2. Adjust belt tension
and off	3. Blower shaft tight or		3.	Oil or replace bearings
		locked		(Disconnect unit)
	4.	Bearings dry	4.	Oil bearings
	5. Motor pulley diameter		5. Adjust pulley so full load
		too large causing motor		ampere rating of motor
		overload		is not exceeded
	6.	Faulty motor	6.	Replace motor
Noisy	1.	Bearings dry	1.	Oil bearings
	2. Wheel rubbing blower		2. Inspect and realign (Dis-
		housing		connect unit)
	3.	Loose parts	3. Tighten loose parts
Inadequate	1. Inadequate exhaust in		1. Open windows or doors
cooling		house		to increase air flow
	2.	Pads not wet	2. Check water distribution
				system
	• Pads plugged		• Clean pads
	• Open spots in pads		• Repack pads
	•	Trough holes clogged	•	Clean
	• Pump not working prop-		• Replace or clean pump
		erly		(Unplug)
Excessive	1.	Inadequate exhaust	1.	Open doors or windows
humidity in
house

Register your product online at: www.championcooler.com/eac/onlineregistration-eac.htm

Limited Warranty

This warranty is extended to the original purchaser of an evaporative cooler installed and used under normal conditions. It does not cover damages incurred through accident, neglect, or abuse by the owner. We do not authorize any person or representative to assume for us any other or different liability in con- nection with this product.

Terms And Conditions Of Warranty

For Five Years from date of purchase, we will replace the base assembly if water leakage should occur due to rust out.

For One Year from date of purchase, we will replace any original cabinet component which fails due to defect in material or factory workmanship only.

Exclusions From The Warranty

We are not responsible for replacement of cooler pads. These are disposable components and should be replaced periodically. We are not responsible for any incidental or consequential damage resulting from any malfunction.

We are not responsible for any damage received from the use of water softeners, chemicals, descale material, plastic wrap or if a motor of a higher horsepower than what is shown on the serial plate is used in the unit.

We are not responsible for the cost of service calls to diagnose cause of trouble, or labor charge to repair and/or replace parts.

How To Obtain Service Under This Warranty

Contact the Dealer where you purchased the evaporative cooler. If for any reason you are not satisfied with the response from the dealer, contact the Customer Service Department: 5800 Murray Street, Little Rock, Arkansas 72209. 1-800-643-8341. E-mail: info@championcooler.com, Web: www. championcooler.com.

This limited warranty applies to original purchaser only.

110525 5