SOUND 140 OWNER’S MANUAL
REMOTE CONTROL BATTERY
The remote control battery has been previously installed and is ready for operation. When the remote control stops functioning, you must replace the battery with a new one. To do so, locate the battery com- partment on the bottom of the remote and follow the steps below:
1.Squeeze the small notch while pulling the ‘battery door latch ’ out towards you. This will allow the battery holder to release and pop out.
2.Insert a CR2025, 3V lithium battery. Make certain to follow the correct polarity, following the directions of the corresponding symbols
3.Secure the battery and push the battery holder back into the remote control until fully inserted.
Location of Controls on the Main Unit
Front Panel: |
|
A) Knob | F) Tune + |
B) Sleep | G) Tune – |
C) Source | H) IR sensor |
D) Play/Pause | I) Light sensor |
E) Set |
|
