SYSTEM SET CODES AND THE SYSTEM SET CODE TABLE continued
CHANGING SYSTEM SET CODES
To enter a system code of your choice, use the procedure below.
1.Turn off the radio.
2.Press/release the ‘Sys. Set’ button (13). Note that ‘- - ‘ (41) appears in the upper right corner of the display and the clock digits disappear.
3.Within 5 seconds, enter the desired numeric code with the numeric key pad, then immediately press/release the button labeled ENTER. The code ICON (42) will briefly appear in the lower right corner of the display.
CHANGING THE CLOCK FROM 24 TO 12 HOUR FORMAT – AN EXAMPLE OF CHANGING A SYSTEM SET CODE
The instructions below serve as an excellent example of how to change a system set code, in this case changing the clock system to a 12 hour format:
1.Turn off the radio.
2.Press/release the ‘Sys. Set’ button. Note that ‘- - ‘ appears in the upper right corner of the display and the clock digits disappear.
3.Within 5 seconds, enter 12 with the numeric keypad, then immediately press/release the button labeled ENTER. ‘12H’ briefly appears in the display.
E100 OPERATION MANUAL
SYSTEM SET CODES AND THE SYSTEM SET CODE TABLE continued
DEFAULT FACTORY SYSTEM SET CODES
When shipped from the factory, the radio’s System Set Code Table is set up as follows. Changes can be made via the procedure shown in the section titled CHANGING SYSTEM SET CODES.
•Radio alarm uses last station tuned. Code 02.
•Eight pages with 25 memories (200 memories total).Code 08.
•10 KHz AM (MW) tuning rate. Code 10.
•24 hour clock system. Code 24.
•1.5 Volt AA batteries. Code 29.
•
MONITORING CURRENT SET CODE STATUS
In the System Set Code Table, the current status of the set codes identified with an asterisk (*) can be monitored by performing a 3 second press of the ‘Sys. Set’ button. The applicable icon shows briefly in the display window for each code.
22 | 23 |
