GLOBE TRAVELER G3 OWNER’S MANUAL | GLOBE TRAVELER G3 OWNER’S MANUAL |
F1-7 DUAL FUNCTION BUTTON DIAGRAM
The
CHARGING Ni-MH BATTERIES IN THE G3
With its included AC adapter/charger connected, the G3 internally recharges 4
To charge batteries:
1.Connect the AC adapter/charger.
2.With the G3 turned off, install 4
3.Press the F7 button for about 3 seconds, or until CHARGE 00 appears in the display.
4.Use the tuning knob to select the charging time in hours
5.In the display, the battery symbol’s segments continuously activate from left to right during charging. Battery charging terminates once the set charge time has been reached.
INITIAL SETTINGS
Assure that it is powered with the AC adapter or batteries, that it is unlocked and that the DX/LOCAL switch (left side panel) is in the DX position (up).
SETTING UP AM AND FM OUTSIDE OF
NORTH AMERICA
To use the G3 in North America (U.S. or Canada), no changes to the initial factory settings are needed.
In North America, AM stations are spaced by 10 KHz. In Europe and other areas, they are spaced by 9 KHz. In North America, the FM band begins at 87.5 MHz. In other parts of the world, it may begin at 76 MHz. Follow these steps to set this for your area:
1.With the G3 off, press the F5 button for about 3 seconds – ‘9’ or ‘10’ flashes in the display.
2.Use sequential F5 presses to select 9 or 10, then press the ‘PAGE/TIME’ button – the FM frequency flashes in the display.
3.Sequentially press the F5 button until the beginning FM frequency of your area appears, then press PAGE/TIME.
VOLUME CONTROL
With the G3 on or off, use the
SELECTING LW, AM, FM, AIRCRAFT BAND AND SHORTWAVE
Please note that in North America no Longwave (LW) stations are broadcasting on this band and that you may hear broadcast band images.
6 | 7 |
|
|