Eton G3 owner manual SETTING ALARMS 1 THROUGH 4 continued, Activating And Deactivating The Alarms

GLOBE TRAVELER G3 OWNER’S MANUAL GLOBE TRAVELER G3 OWNER’S MANUAL

SETTING ALARMS 1 THROUGH 4 continued

8.Skip this step if you want to use the last frequency tuned to wake to. While the page number is in the display press one of the F1-7 buttons to select the memory location on the selected page of the frequency you want to wake to (the square flashes).

9.Press the PAGE/TIME button to finish the set-up.

ACTIVATING AND DEACTIVATING THE ALARMS

For an alarm to turn the radio on, it must be activated. To activate the alarm to be used, turn off the G3 and press the appropriate alarm button, F1-4. This causes the timer activation symbol to appear in the upper left corner of the display, activating the selected alarm. To deactivate the alarm, press the appropriate F1-4 button, causing the alarm activation symbol to disappear.

USING THE LIGHT

The light illuminates the display and buttons. Turn it on and off by pressing the LIGHT button. When using batteries the light stays on for about 6 seconds; when using an AC adapter it stays on indefinitely or until turned off.

EXTERNAL ANTENNA SOCKET

The external antenna socket is used to connect the G3 to advanced performance shortwave antennas using a 50 or 75-Ohm coaxial cable feed-line.

FM STEREO/MONO SELECTION

When listening to FM stations, stereo/mono is selected automatically depending on the quality of the audio from the station.

LINE-IN/OUT SOCKET

This socket provides an industry standard, fixed level audio input/output source for safely routing the G3’s audio to the line-in socket of a stereo system or recording device, or playing an audio device, such as MP3, through the G3.

To route a line-in source into the G3, turn it off, attach a double 1/8 inch (3.5mm) stereo cord to the G3’s LINE –IN/OUT socket and to the output of the other system. Press the G3’s LINE-IN button, labeled

TZ/LINE-IN.

To route the audio output of your G3 to another device, turn it on, plug a 1/8 inch (3.5mm) stereo cord into the G3’s LINE-IN/OUT socket and into the other device’s LINE-IN socket. Follow your external device’s line-input/ output instructions.

EARPHONE SOCKET AND USING EARPHONES (not included)

Plug them into the earphone socket on the left side of the radio. Turn the volume down before wearing the earphones, then turn up the volume to your liking.

REAR FOLDING STAND

Pull the folding stand from the rear of the G3, allowing viewing at a comfortable angle.

RESET BUTTON

The reset button is located inside the small hole labeled RESET on the right front of the radio. If the G3 operates erratically, poke a paper clip into the reset hole to reset its microprocessor. This does not erase memory, but does reset the clock to 12:00.

18 19