Euphonix System 5 Installation Guide System 5 Components
35
FC631 Frame Controller
AES Sync In (3-pin Lemo Female): The DF64 Digital Frame clocks to the signal at this
port when the sync source is set to AES Sync. Connect this port to a digital sync reference.
AES Sync Out (3-pin Lemo Male): This signal is active regardless of the selected sync
source.
Word In (BNC): The DF64 clocks to the signal at this port when the sync source is set to
Word Clock. Connect this port to a digital sync reference.
Word Out (BNC): This signal is active regardless of selected sync source.
IEEE 1394 ports (2): High speed communication interface to the PC253d Digital Pilot
Computer. This interface carries real-time control and metering data between the PC253d
and the DF64. Connect either port to any of the IEEE 1394 ports on the dedicated PC253d
for this frame via firewire (provided).
MM641 MADI Interface Card
MADI In (4) and MADI Out (4) (8 BNC): Digital audio in and outs. See the MADI Hookup
diagrams (Figure 2-9 and Figure 2-8) for details on these connections.
SP661 Signal Processor
This card has no connections.
System 5 Console
The System 5 Console consists of several modular components: the CM401 and CM402
(console center section), the CM408 (contains eight physical faders and controls), the
CM403 (contains the joystick panner panel and film monitor panel), and the CM409HTP
Track Panner Module. Each component has the following connections:
Power Connector (IEC): Accepts standard IEC power cord (provided). An autoranging
switching supply accepts voltages between 100–240 VAC, 50–60 Hz.
Network Port (RJ45): Connect to EuCon Network Hub via RJ45 through the console
ethernet harness (provided).
Expansion Port (DB25): Active on the CM401 only. Connect talkback switches here.