Eureka 2970 Periodic Maintenance How To Replace Brushroll Belt, Return vacuum to upright position

FIG. 21

Edge Kleen™ model shown (some models only)

Modèle Edge Kleen™ illustré (certains modèles seulement)

Se muestra el modelo Edge Kleen™ (sólo algunos modelos) FIG. 22

Edge Kleen™ model shown (some models only)

Modèle Edge Kleen™ illustré (certains modèles seulement)

Se muestra el modelo Edge Kleen™ (sólo algunos modelos)

FIG. 23

Edge Kleen™ model shown (some models only)

Modèle Edge Kleen™ illustré (certains modèles seulement)

Se muestra el modelo Edge Kleen™

(sólo algunos modelos)

FIG. 24

Edge Kleen™ model shown (some models only)

Modèle Edge Kleen™ illustré (certains modèles seulement)

Se muestra el modelo Edge Kleen™

(sólo algunos modelos)

14 FIG. 25

ENGLISH

PERIODIC MAINTENANCE (continued)

How To Replace Brushroll Belt

Step 1: Lower handle to floor to change belt (FIG. 21).

Step 2: Remove the two screws from the top of the hood (FIG. 22).

Step 3: Lift hood to remove (FIG. 23).

Step 4: Lift right end of brushroll (FIG. 24).

Step 5: Remove and discard belt.

Step 6: Place new belt around motor shaft.

Step 7: Place new belt around brushroll pulley.

Step 8: Align left end cap with base. Push end cap securely into place. Make sure the square on the brushroll cap is in place (FIG. 25).

Step 9: Pull right side of brushroll to stretch belt. Secure right end cap into base.

IMPORTANT

Step 10: Rotate brushroll by hand 2 full rotations to properly position belt.

Step 11: Place hood back on cleaner. Replace and tighten two screws.

Step 12: Return vacuum to upright position.

(CONTINUED)