HOW TO MAINTAIN
The instructions in this booklet serve as a guide to routine maintenance. To avoid unnecessary service calls, check the bag, belt, and brush roll often.
Brush Roll
The brush roll turns as it sweeps and combs the carpet nap. Remove hair and threads from the brush roll so it continues brushing the carpet. To maintain the most efficient cleaning, the bristles must touch the carpet. To test the bristle length, hold a ruler against the underneath side of the cleaner. If the bristles no longer touch the ruler, replace the brush roll.
Brush Roll Belt
4
Motor
Pulley
Belt
Brush
Roll
3
3.Lift left end of brush roll.
4.Remove and discard belt.
The brush roll belt turns the brush roll to agitate, sweep, and comb the carpet nap. Check the belt regularly to be sure it is in good condition. Replace the belt if it stretches, cracks or loses tension. Cut away any hair or threads wound around the brush roll or the belt pulley because the buildup could cause the belt to rotate unevenly.
How To Replace Brush Roll Belt
NOTE: Turn off the switch and unplug the electrical cord before replacing belt. Belt pulleys can become hot during normal use. To prevent injury, avoid touching the motor pulley when checking the belt.
5
7
Left Side View
5.Place new belt around motor pulley.
6
2
1
2
1.Lower handle to floor to change belt.
2.Loosen, but do not remove, two screws to release hood. Lift hood to remove.
6. Place belt around brush roll pulley.
7. Align left end cap with square in base. Push end cap into place; see left side view.
8. Pull right side of brush roll to stretch belt. Se- cure right end cap into
8base.
9.Rotate brush roll to seat belt.
10.Replace the hood. Make
sure hood front is behind furniture guard. Hood
9 should seat onto self- locating screw tabs.
11. Tighten screws.
Use GENUINE EUREKA replacement belt, 61120. Look for the GENUINE EUREKA product symbol.
8
