Eureka 4750 manual How To Maintain, Brushroll Belt, To Change Belt, English

	FIG. 19a
	FIG. 19
20	FIG. 20

ENGLISH

HOW TO MAINTAIN

The instructions in this booklet serve as a guide to routine maintenance. To avoid unnecessary service calls, check the dust bag, belt, and brushroll often.

Brushroll

The brushroll turns as it sweeps and combs the carpet nap. Remove hair and threads from the brushroll so it continues brushing the carpet. To maintain the most efficient cleaning, the bristles must touch the carpet. To test the bristle length, hold a ruler against the underneath side of the cleaner. If the bristles no longer touch the ruler, replace the brushroll.

Brushroll Belt

Brushroll Performance Window (FIG. 19) To check condition of belt watch to see if white dots on belt are moving through the performance window (FIG. 19a). This indicates the brushroll is turning.

The brushroll belt turns the brushroll to agitate, sweep, and comb the carpet nap. Check the belt regularly to be sure it is in good condition. Replace the belt if it stretches, cracks or loses tension. Cut away any hair or threads wound around the brushroll or the belt pulley because the buildup could cause the belt to rotate unevenly.

To Change Belt

(FIG. 20) Use belt, Style U 54312 or Style EXT-U 61120.

CAUTION: Turn off the switch and unplug the electrical cord before replacing belt. Motor shaft can become hot during normal use. To prevent injury, avoid touching the motor shaft when checking the belt.

Step 1: Lower handle to floor to change belt.

Step 2: (FIG. 19) Remove two screws to release hood.

Lift hood to expose belt and brushroll.

Step 3: Lift left end of brushroll and pull out of base.

Step 4: Remove and discard belt.

Step 5: Clean debris from brushroll area.

Step 6: Place new belt around motor shaft.

Step 7: Place belt around right side of brushroll.

Step 8: Pull right side of brushroll to stretch belt. Secure right end cap into base.

Step 9: Align left end cap with square in base. Push end cap into place.

Step 10: Rotate brushroll to position belt on brushroll pulley.

Step 11: Replace the hood.

Step 12: Tighten screws.

(CONTINUED)