! How to Maintain YourVacuum Cleaner
Make sure vacuum cleaner is turned off and power cord is unplugged.
Maintain Brush Roll – Call Eureka Customer Service HELPLINE – Part number
Do not remove end caps. Remove hair and threads from brush roll periodically.
Replace
!Motor can become hot with normal use.
1)Use handle release to lower handle flat onto floor. Turn vacuum over on its backside and remove 4 screws (Fig. 1).
2)Turn vacuum over to front side and remove brush roll cover (Fig. 2).
3)Remove brush roll and belt (Fig. 3).
4)Thread new belt around motor shaft and then the brush roll (Fig. 4).
5)Insert left end of brush roll first and then the right end (Fig. 5).
6)Rotate brush roll 2 turns to center belt.
7)Replace brush roll cover (Fig. 2). Turn vacuum over on its backside.
8)Replace screws ➌&➍ closest to the brush➀roll➁first. Then replace screws & (Fig 6).
➀ | ➁ |
➂ | ➃ |
Fig. 1 |
|
Fig. 3 |
Fig. 5 |
Fig. 2
Fig. 4 |
➀ | ➁ |
➌ | ➍ |
Fig. 6 |
|
Change Light Bulb – Part number 57940-3
!Make sure vacuum is turned off and power cord is unplugged.
1)Remove HEPA filter. See directions
on page 2 for removing the HEPA filter.
2)Unscrew the lens and remove old bulb (Fig. 7).
3)Push in new bulb, replace lens cover and replace screw back into place (Fig. 8).
4)Replace HEPA filter, filter door, foam filter and frame and secure dust cup.
Fig. 7 |
Fig. 8
4 | Eureka Customer Service HELPLINE | www.eureka.com |
