Eurotech Appliances EDW242C, EDW274E English, FITTING THE EDW294E ONE-PIECECUSTOM DOOR PANEL

FITTING THE EDW294E ONE-PIECE CUSTOM DOOR PANEL

Model EDW294E can only be installed with a one-piece custom door panel that extends from the toe kick to the counter top. The unit comes with everything needed to make installing the door panel easy. The door is predrilled for the panel’s mounting screws.

To order a one-piece door, contact your dealer. The part numbers are listed below:

White 750163400

Black 750163600

Bisque 750163700

Stainless Steel 750163800

ITEMS PROVIDED WITH THE ONE-PIECE DOOR PANELS

These items are supplied with the doors:

←One-piece door

←Color-coordinated toe kick

←Door handle

←Handle support bracket

←Two 1/2” machine screws for handle

←Two 1/2” sheet metal screws for toe kick

INSTALLING THE ONE-PIECE CUSTOM DOOR PANEL

Before fitting the custom panel, the dishwasher must be installed underneath the cabinet.

For this installation, we recommend that you install the 2” fill strip (see page 6) that comes with the unit to hide the top of the dishwasher and further reduce water noise.

NOTE: Do not fasten the dishwasher to the cabinet until after you have installed the door panel.

1.Remove the custom panel and parts from the packaging.

2.Move the insulation on the back of the custom panel.

3.Slide the handle support bracket to the inside top of the panel.

4.Insert the screws through the support bracket and the panel.

5.Fit the door handle to the screws and secure tightly.

6.Remove the rubber gaskets from inside the dishwasher door and discard.

7.Remove the second and fourth screws from the inside top of the dishwasher door (as illustrated) and discard.

8.With the door slightly open, position the panel with the holes in alignment with the door holes and secure it in place with 2-12” squeeze clamps on both sides.

9.Insert the 1-1/2” screws partially through the dishwasher door.

10.Loosen the clamp on one side enough to align the screws with the holes in the panel.

11.Secure the screws.

12.Repeat steps 9 and 10 for the other side.

13.Close the door and, if necessary, adjust for square by adjusting the front levelling legs for proper height clearance.

14. Fasten the dishwasher to the cabinet (see page 9).	With this installation,
	the custom panel
	extends 1-13/16”
	inches above the
	dishwasher control
	panel, as illustrated.

ENGLISH

13