WOOD PANELS THE SAME HEIGHT AS THE DISHWASHER DOOR (23-1/4”)

If the custom panel is the same height as the dishwasher door, a 2” decorative fill strip or pull-out cutting board must be used to fill the area between the panel and the counter top (as illustrated at right).

INSTALLING A CUSTOM WOOD PANEL

To install the custom wood panel, follow the steps below.

1.Attach the handle (A) to the wood panel. (It is best to use a handle instead of a knob.)

2.Remove the second and fourth screws (B and C) from the inside top of the dishwasher door and discard.

3.With the door slightly open, position the wood panel with the holes in alignment with the door and secure it in place with 2-12” squeeze clamps on both sides.

4.If you are installing a 30-1/16” high panel, it should extend 1-13/16” above the control panel. It’s a good idea to take this measurement before you proceed.

5.Insert the 1-1/2” screws supplied with the unit through the panel and door.

6.Secure the screws.

7.Close the door and, if necessary, adjust level by adjusting the front levelling legs for proper height clearance.

8.Fasten the dishwasher to the cabinet (see page 9).

Note: If your wood panel is less than 3/4" thick, the screws supplied with the unit will not work. You must purchase shorter screws that will not puncture the wood panel from a local hardware store.

ENGLISH

15

Page 15
Image 15
Eurotech Appliances EDW254E Installing a Custom Wood Panel, Wood Panels the Same Height AS the Dishwasher Door 23-1/4