EDW274E Programs, Adding AN Item | Eurotech Appliances EDW294E

for this option are as follows:

A0	= no dry	A2 = 35 minutes
A1	= 20 minutes	A3 = 45 minutes

START BUTTON

After you have selected the wash program and option(s) you prefer, press this button to start a program. Asignal will sound to indicate the program has begun and the LCD will display the program run time.

INDICATOR LIGHTS

The On light indicates that the power to the unit is on. The Rinse Aid light glows when you need to add rinse aid. (See page 20 for instructions on how to load the rinse aid dispenser.)

ADDING AN ITEM

WARNING!

Be extremely careful when opening the door during a program. The water is hot and you could get scalded.

To add an item after a program has started, open the door slightly until the spray arms stop turning. You can then open the door fully and place the item into the dishwasher. Close the door and press the Start button to restart the program from where it stopped.

CANCELLING A PROGRAM

To cancel a program after it has started, press and hold the Start button until the unit beeps and the program display shows P1-P8. If the display shows “00” turn the unit off then back on to clear the program.

You will have to reselect the program and options and press Start again to restart the unit. Before you restart the unit, make sure the detergent dispenser is still closed; otherwise, you will have to add detergent.

END-OF-PROGRAM BUZZER

At the end of the program, a prolonged buzzer will sound to indicate the program is complete. To disable (or enable) the buzzer, follow the instructions below:

1.Turn the power off.

2.Press and hold the Program button while your press the On/Off button. The LCD will display one of the following:

B0 = buzzer is on

B1 = buzzer is off

3.Press the Program button to toggle between B0 and B1. Release the Program button when your preference displays.

4.Wait six seconds for the change to be set. A short beep will sound when the change is accepted.